Contributed by Alex Nash. 6 June 1996.
The Cyclades multiport cards are based on the cy driver instead of the usual sio driver used by other multiport cards. Configuration is a simple matter of:
Add the cy device to your kernel configuration (note that your irq and iomem settings may differ).
device cy0 at isa? irq 10 iomem 0xd4000 iosiz 0x2000
Rebuild and install the new kernel.
Make the device nodes by typing (the following example assumes an 8-port board)[1]:
# cd /dev # for i in 0 1 2 3 4 5 6 7;do ./MAKEDEV cuac$i ttyc$i;done
If appropriate, add dialup entries to /etc/ttys by duplicating serial device (ttyd) entries and using ttyc in place of ttyd. For example:
ttyc0 "/usr/libexec/getty std.38400" unknown on insecure ttyc1 "/usr/libexec/getty std.38400" unknown on insecure ttyc2 "/usr/libexec/getty std.38400" unknown on insecure … ttyc7 "/usr/libexec/getty std.38400" unknown on insecure
Reboot with the new kernel.
| [1] |
You can omit this part if you are running FreeBSD 5.X with devfs(5). |