During the development stage, a few users reported problems with normal configuration. Some of these problems are listed below:
multilabel option cannot be enabled on /The multilabel flag does not stay enabled on my root
(/) partition!
It seems that one out of every fifty users has this problem, indeed, we had this problem during our initial configuration. Further observation of this so called “bug” has lead me to believe that it is a result of either incorrect documentation or misinterpretation of the documentation. Regardless of why it happened, the following steps may be taken to resolve it:
Edit /etc/fstab and set the root partition at ro for read-only.
Reboot into single user mode.
Run tunefs -l enable on /.
Reboot the system into normal mode.
Run mount -urw / and change the ro back to rw in /etc/fstab and reboot the
system again.
Double-check the output from the mount to ensure that
multilabel has been properly set on the root file
system.
After establishing a secure environment with MAC, I am no longer able to start X!
This could be caused by the MAC partition policy or by a mislabeling in one of the MAC labeling policies. To debug, try the following:
Check the error message; if the user is in the insecure class, the partition policy may be the culprit. Try setting the user's class back to the default class and rebuild the database with the cap_mkdb command. If this does not alleviate the problem, go to step two.
Double-check the label policies. Ensure that the policies are set correctly for the user in question, the X11 application, and the /dev entries.
If neither of these resolve the problem, send the error message and a description of your environment to the TrustedBSD discussion lists located at the TrustedBSD website or to the FreeBSD general questions 郵遞論壇 mailing list.
When I attempt to switch from the root to another user in the system, the error message “_secure_path: unable to state .login_conf”.
This message is usually shown when the user has a higher label setting then that
of the user whom they are attempting to become. For instance a user on the system,
joe, has a default label of biba/low. The root user, who has a
label of biba/high, cannot view joe's home directory. This will happen regardless if root has used the su command to
become joe, or not. In this scenario, the Biba integrity
model will not permit root to view objects set at a lower
integrity level.
In normal or even single user mode, the root is not recognized. The whoami command returns 0 (zero) and su returns “who are you?”. What could be going on?
This can happen if a labeling policy has been disabled, either by a sysctl(8) or the
policy module was unloaded. If the policy is being disabled or has been temporarily
disabled, then the login capabilities database needs to be reconfigured with
the label option being removed. Double check the login.conf file to ensure that all label options have been removed and rebuild the database with
the cap_mkdb command.
本文及其他文件，可由此下載：ftp://ftp.FreeBSD.org/pub/FreeBSD/doc/。
若有 FreeBSD 方面疑問，請先閱讀 FreeBSD 相關文件，如不能解決的話，再洽詢
<questions@FreeBSD.org>。
關於本文件的問題，請洽詢 <doc@FreeBSD.org>。